At a glance
ClinicalIndex Comparison RecordStandardized by ClinicalIndex from the ClinicalTrials.gov record · verify against the source.
Retention Rate and Caries Preventive Effect of Preheated Flowable Resin Composite Used as a Pit and Fissure Sealant Versus Conventional Resin-based Fissure Sealant in Patients With Permanent Molars With Deep Pit and Fissure Over One Year Follow up. A Randomized Clinical Trial
In Brief
A clinical study evaluating Pre-heating of flowable resin composite used as a pit and fissure sealant. and Conventional resin fissure sealant for Pit and Fissure Sealant. Completed, enrolled 28 participants across 1 site.
Detailed Summary
Retention rate and caries preventive effect of preheated flowable resin composite used as a pit and fissure sealant versus conventional resin-based fissure sealant in patients with permanent molars with deep pit and fissure over one year follow up. A randomized clinical trial
Study Details
Timeline
Interventions
The occlusal fissures will be etched with a 37% phosphoric acid gel for 30 s. After rinsing the enamel with water for 30 s the enamel will be dried for 15 s with compressed air. After completing the fissure preparations a single coat of adhesive (3M ESPE ADPER ,USA) will be applied to the etched surface ,dried under gentle air flow for 2- 3 s and light cured for 20 s using a LED light curing unit with a 1000 mw output .Conventional resin fissure sealant (total etch), (UltraSeal XT®, Ultradent, USA) will be applied to the etched pits and fissures. After removing the rubber dam the occlusion will be checked the sealant will be adjusted with a composite finishing bur and polished with polishing points.
The occlusal fissures will be etched with a 37% phosphoric acid gel for 30 s. After rinsing the enamel with water for 30 s the enamel will be dried for 15 s with compressed air. After completing the fissure preparations a single coat of adhesive (3M ESPE ADPER ,USA) will be applied to the etched surface ,dried under gentle air flow for 2- 3 s and light cured for 20 s using a LED light curing unit with a 1000 mw output .Conventional resin fissure sealant (total etch), (UltraSeal XT®, Ultradent, USA) will be applied to the etched pits and fissures. After removing the rubber dam the occlusion will be checked the sealant will be adjusted with a composite finishing bur and polished with polishing points.